BRAKE CALIPER PROBLEM help

hi all
can anyone help me iv,e just fitted a disco 200tdi 10 spline shaft ball and disc to my ninty when i tried to put my 90 brake caliper on it would not fit i can get hold of a set of 200 calipers but they have two brake pipes going into them where as my 90 only has one is their a way i can modify them or will i have to get single pipe calipers.
regards bozz

Get a 3 way, t shape junction ( 1 pipe in 2 pipes out) and use the 200 calipers.

find some one with a old axle and remove the connector block that seperates the single feed pipe to each calliper. and use that. as a 2 into 1 connector

use one pipe and put a bleed nipple in the other hole, its what i did

As said above, the ninety's have a slightly smaller caliper than the Defender's and Disco's, the pistons are 41mm, whereas when they introduced the Defender with the 200tdi, they used 46mm pistons in the calipers, same as Disco one's, but the Defenders only had the one line in the caliper Land Rover creating problems here

Let me get this right you swapped one side for a disco only one side or both?

Gresham

i replaced both sides , but iv,e found the problem when i got them the discs were off so i fitted them back on, them found the caliper did not fit i spoke to him and he told me to get 300tdi calipers as they would fit and they where single pipe so i did.i then found it still did not fit but the passanger side did after a bit of head scratching i found that one of the discs was bigger than the other, the plonker had given me a rear disc ive know fitted new discs and the problems solved happy days,thanks for the advice gents