box section measurements confliction

hi all been doing research regarding replacing the sills with box section.now i know its 100x60x3 but length now ive seen 1450 but also 1400 making a 2" diff.question for those who have done this fix which would be best option pros and cons. im tempted for this Discovery Sill Replacement ? - Steel Box Section 100mm x 60mm x 3mm -1400mm long | eBay


this or 1450mm

ta

measure your sill, allow bit extra and buy that length . from memory I bought 3 metrs and got bit for other side when I need it

uncle albert said:

measure your sill, allow bit extra and buy that length . from memory I bought 3 metrs and got bit for other side when I need it

Click to expand...

yeah i need to get trim popped off and get it measured, just that ive read some used 1400 and some 1450 yet some were i read he ended up 50mm short. cant think were i read it now

andrewblueboy said:

yeah i need to get trim popped off and get it measured, just that ive read some used 1400 and some 1450 yet some were i read he ended up 50mm short. cant think were i read it now

Click to expand...

dont need to . just measure underside from front of rear w/arch to just in front of f/door pillar if you look under you can see it clear enough

uncle albert said:

dont need to . just measure underside from front of rear w/arch to just in front of f/door pillar if you look under you can see it clear enough

Click to expand...

right just been out and measured rear weel arch to end of front sill and comes to 1400. some reason i was thinking it end up towards front middle of the front wing bit.as when plastic trim is removed they be nothin there.

sounds right , by the way got mine from local scrappy , about £15 for both sides

uncle albert said:

sounds right , by the way got mine from local scrappy , about £15 for both sides

Click to expand...

i wish think check the local scrapys etc in the morning if no luck ebay

good luck . its same size as wharehouse shelving or builders merchants racks

I used 120 x 60 on mine as it comes nicely below the door pillars for welding and a bit more protection for rock sliding, but either will do the job, also beware of the body mounts when cutting them off, good luck.

thanks for the infor guys

i dit mine in 11x60, ut wish id have gone 110/120 as it would have given me more to weld tree/rocl sliders to, but def 1400 long.

i cut out the outer sills and my inner ones were good so left it there and used that to weld box to.

Paulmitchell1984 said:

i dit mine in 11x60, ut wish id have gone 110/120 as it would have given me more to weld tree/rocl sliders to, but def 1400 long.

i cut out the outer sills and my inner ones were good so left it there and used that to weld box to.

Click to expand...

yeah ive gone for the 1400 100x60x3 £53 del not bad for the money should be here in next few days