blend motors

is the blend motors the same unit that's used for the air distribution? ie, are they interchangeable?

there all the same, they only have coloured bands on so you get them in the right place when replacing them as a complete set.

You can even buy a single blend motor,it'll have about 4" of flex on it,so you can just joint it to exising cable to save taking it all out.
Either solder joints and heat shrink or use small connector block and insulation tape but connector would have to be on the small side as the motor has 5 no wires
Hope this helps

As ABU says above the blend motors are interchangeable but there is one other type of motor that's different, it only has two wires and so doesn't have the position circuit. I'm sorry I can't remember exactly but I think its probably the recirc one. But if you're buying off ebay etc just be careful as it looks the same from the outside, the better sellers know this and are very clear about which one they are selling.

ffs I'm offering one brand new for free-before I smash and bin it you want it or not?

From memory there's 5 motors in total ,3 in centre that have 5 cables each and the other 2 are 1 each side eg. 1 far left other far right and its the outside ones that have only 2 cables

fanatic said:

ffs I'm offering one brand new for free-before I smash and bin it you want it or not?

Click to expand...

really? u have a spare you would give away?

my distro morot is up the swanny, and want to get a replacment before i pull the dash out. just checking o see if i could use a blend in its place, i guess i can

Gems dad got dibs on it as first to ask for it and yes I'm giving it to him for Free.