- Posts
- 2,427
- Location
- Isle Sheppy
When the nanocom says left hand blend motor fault does it mean looking from the drivers seat or the front of the car cheers
P38A Blend motor location
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ovalandrover
Well-Known Member
- Posts
- 1,610
from drivers seat behind the panel next to glove box
Datatek
Well-Known Member
- Posts
- 45,026
- Location
- Near Poitiers SW France
Nanocom should let you clear the fault and try to drive the blend motor.
- Posts
- 2,427
- Location
- Isle Sheppy
Yer did that data but it says fault persistent
Datatek
Well-Known Member
- Posts
- 45,026
- Location
- Near Poitiers SW France
OK, when you get the blend motor out, check the mechanism it drives is free moving.
- Posts
- 2,427
- Location
- Isle Sheppy
Ok thanks will wait for rain free day then dash will be out cheers
Datatek
Well-Known Member
- Posts
- 45,026
- Location
- Near Poitiers SW France
No need for the dash out unless the mechanism is stuck.
- Posts
- 2,427
- Location
- Isle Sheppy
Just been out and checked it again on nanocom it's working the blend motors but it says left blower 119 right blower 0 so that may account for the book symbol
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
you can get to the right hand motor through the speedo binnacle and the under steering panel and tunnel side piece
- Posts
- 2,427
- Location
- Isle Sheppy
When u say right hand motor do u mean blend motor or right side blower or they the same part thanks
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
blend motor
- Posts
- 2,427
- Location
- Isle Sheppy
Oh ok coz the nanocom says right blower
tarphenry
Well-Known Member
- Posts
- 1,540
- Location
- bury lancs
Ibelieve the right blower is easier to acces than the blend motor. if you look in RAVE, it will show you where it is
Datatek
Well-Known Member
- Posts
- 45,026
- Location
- Near Poitiers SW France
Remove the pollen filter and look see with a torch, the blower hosing may be full of crap. Other wise its likely to be the motor speed controller that has failed. Can be repaired, but easier to replace if you don't have electronics knowledge.
- Posts
- 2,427
- Location
- Isle Sheppy
Cheers data will check that 1st
- Posts
- 2,427
- Location
- Isle Sheppy
Just checked behind polen filter all clear but one of the relays is a bit burnt so swapped with another one but still same fault is it best to replace relays with original or can I use other makes
Datatek
Well-Known Member
- Posts
- 45,026
- Location
- Near Poitiers SW France
You now have 2 threads going on this! As I said, most likely the fuse box where the relay plugs in is fecked. Common problem, may be fixable. The burning is caused by poor contact between the relay pins and the receptacles in the fue box.
- Posts
- 2,427
- Location
- Isle Sheppy
Yer posted new thread because this one started about heater matrix
