Before i set off off road.....

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
E

ellodave

Member
Posts
86
Location
Treherbert Rhondda South wales
Is there anything i should change/renew before hitting the muddy stuff? I have done the following.

  1. 2" lift springs with + 5 inch shocks
  2. Extended brake and bump stops
  3. steering guard
  4. snorkel
  5. 265 75 16 insa turbo special track's
  6. camel cut/triming stuff.
  7. new donut
  8. removed anti roll bars
However is there anything I should change that normally break once you take a disco off road ie bush's/joints etc??

Thanks :)
 
Learn to drive off road. Either go with a groupe. Or go to a pay and play day if you want to go solo at least then there will be help if it all goes wrong.
 
It really doesn't matter how tricked up your vehicle is there is no substitute for experience.
1st low gear for steep descents
2nd low to climb hills.
Gentle throttle through mud etc, when you loose traction back off the throttle and let the insa turbos grip.
 
Get another donut in stock ready for when that 1 gives up. Even if it new,if your cross axling alot it will kill it.
 
Funkykipper said:
It really doesn't matter how tricked up your vehicle is there is no substitute for experience.
1st low gear for steep descents
2nd low to climb hills.
Gentle throttle through mud etc, when you loose traction back off the throttle and let the insa turbos grip.
Click to expand...

Thanks

Im pretty good at driving off road never really got stuck in my SJ and only broke 1 shaft the whole time i had it. But i was wondering if the disco's where prone for stuff breaking? like trailering arm bush's? or rear diff centre bearing bush thing etc
 
umm try get one with an su carb as the standard carb's are crap when you show them some dust/mud. I never liked the SPOA or spring over axle conversion as i found it to unstable. also avoid lift shackles that stick down like ladders they dig in and can bend the springs. RUST! behind seat's, boot floor, wheel arches front and rear prettty much check everywhere as any rust is going to be an MOT failure due to them being small the rust is going to be near either a body mount or seat belt ancour. also worth check the bottomend is not knocking, mine did for just over a year mind before it finally blow up!
 
The donuts aren't that ****e. Mines been on 4 years now with a lift and lots of off roading and still going strong. I've had to replace the ujs more
Often... Do the +5in shocks not bottom out?
 
RKServicing said:
The donuts aren't that ****e. Mines been on 4 years now with a lift and lots of off roading and still going strong. I've had to replace the ujs more
Often... Do the +5in shocks not bottom out?
Click to expand...

I must be unlucky with mine.Last 1 had a month driving on road and a pay and play at tidworth killed it. The 1 before that lasted 3 trials.Roll on pay day when I can retro fit the 200 prop.
 
Must admit a couple of my muddy mates have all changed from 300 props to 200 just to eliminate the donut problem,if u r lucky it will last ages but most people I know that had them,havnt anymore lol
200 prop all the way : )
 
You must log in or register to reply here.

Similar threads

300bhp/ton
Freelander vs Range Rover off road flex test....
Replies
16
Views
4K
GrumpyGel
GrumpyGel
K
What money should I be asking?
2
Replies
27
Views
5K
Karls
K
H
Yes folks! It's tyre pressures again....
Replies
7
Views
2K
Hector the Bad
H
2
How to stop wheels hitting inner arch
Replies
12
Views
3K
Stanleysteamer
Stanleysteamer
proto57
Freelander 2 (LR2) Trouble Diagnosing Drivetrain Issue
Replies
15
Views
3K
GrumpyGel
GrumpyGel
Back
Top