battery terminals with provision for extra leads

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
frontfusebox.jpg


Photo26-05-2013165522.jpg


This is what my CB and front bumper / internal equipment goes through. I have another fuse box and relay system in the boot for the roof rack.

In this fuse box is from left to right,

Bonnet amber strobe relay
Overhead switch panel feed + Rally map light
Driving Lamp switch panel feed.
Footwell Leds
CB
Dash Aux sockets (2 mounted on the back of the binnacle)
Driving lamps (Bonnet) relay feed.
is the red wire leading to the earth, do not get me wrong good job
 
That main red is a 6mm feed directly from the primary battery to the positive bus bar. In the top picture you can then see the feeds (little red ones) coming through onto the fuse box, with the loads coming off the back side.
 
2014-05-2017.56.13.jpg


Lights and heater circuits and 12V 100A buss bar from battery.

P1040788.JPG

Inside aux fusebox - 70A controlled by realy

P1040777.JPG

Inside earth bus
 
bless u guys there is some great help here and really helped

the wiring for the spots and fogs is from a land rover wiring loom i bought off ebay

has all the relays, fuses, switches etc all built in, so it was just a case of plugging it all in,

fitted the small binnacle plate and switches in the small cuddy hole just below the rh side of the steering wheels, ran all the loom whilst i had the interior out as i thought it being an ideal time to do so,

just need a postive and earth to go onto the battery, positive was no problem as it had a 10 mm bolt but will now take a positive feed onto a secondary fuse box and pick up earths as i need them around the car

like the idea about taking power from the radio and as u say wont be left on

adapted the centre console to accept the cb, will take a pic and put it on here

got to run the cb wire which is at the back already through my rear door and onto the bracket, seen the different routes people have taken, through existing grommets so its all neat and tidy and tucked out of the way

now i have the mechanical side done, wish to fit all the bits, ie leds inside, spots, fogs, read light, cb, extra power point at the rear for my cooler which i use to keep the dogs food and water cool when we go out, there not spoilt , honest, lol

need to take some more pics of what ive done and share as like everything if it helps someone else as ive been helped always nice to report back

these are my spots ive just fitted

thks again so much for the great assistance
 

Attachments

  • image.jpg
    image.jpg
    362.3 KB · Views: 118
Last edited:
Back
Top