Hi folks, i have finally got round to ordering a replacement battery tray for my 90 so i am going to paint it, insulate it and install a battery clamp and a kill switch at the same time. Am i best just cutting into the live feed from the battery and adding new terminals to connect to the kill switch? Or replacing the wiring with new? I have a kill switch fitted with a relay so that i can leave the alarm on too. Also any idea where i can get bolts long enough for a battery clamp? Thanks
Battery kill switch
- Thread starter alibream
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Edlen
New Member
- Posts
- 46
- Location
- Dorset/Hampshire border
The battery tray has slots that take hooked lengths of threaded steel which take the nuts that hold the battery clamp
http://www.lrseries.com/shop/product/listing/7876/3007/1/562953-BATTERY-J-BOLT.html?limit=0
http://www.lrseries.com/shop/product/listing/7876/3007/1/562953-BATTERY-J-BOLT.html?limit=0
Last edited:
lanny man 90
Well-Known Member
- Posts
- 2,181
- Location
- in a house that's in a street
Edlen
New Member
- Posts
- 46
- Location
- Dorset/Hampshire border
Then you will need to drill into the yrm panel to lock it down otherwise your tray will just bounce around.
jai_landrover
Well-Known Member
- Posts
- 13,392
- Location
- Luton
I made my own twin clamp using 3 pieces of threaded rod and some angle simple and cheap and very secure
