Series 3 Axle Leaks

So, my 1984 series 3 had been sitting in a barn for 13 years so no surprise, it leaks from everywhere. I have leaks inside both front wheels which I have read is mainly due to swivel balls and seals so I will but new kits for those (about 100 quid each I think).

My rear axle has leaks from the outside of the hubs and I thought it was down to the hub caps being perished so I replaced those (found they had plastic defender hub caps due to it being a very late series 3). It still leaks around the rear hubs so trying to figure what seals/parts I need to sort this out? Anyone?

There's a simple paper oil seal behind the drive flange which you need to replace. It'll stop the leaks at the hubs. They cost diddly. Part no : 231505. Or hub n bearing oil seal kit RTC3534. Up on axle stands and you'll need a Torgeir wrench to nip up the flange bolts.

Stupid spell check on my phone. Meant torque wrench .

Says RTC3534 is for pre 80 landys?

Just be careful with ages my series 3 is a 1982 but has pre 1980 axles. Meant I ordered all the wrong bearings and seals, pre 1980 bearings are different sizes to each other after 1980 they are the same. They obviously still had a lot in stock!

It's just the paper ones you need.

got the paper ones, felt ones and looks like rubber ones

Always worth checking breathers are not blocked as well but given yours has been stood awhile not likely in this case

How do I check the breathers?