ovalandrover
Well-Known Member
- Posts
- 1,632
I was wondering if anyone has changed their zf HP 22 for a hp 24 and if the torque converter from the 22 will fit on the 24 if it does not is there a torque converter that will fit ?
P38A Auto Box change
- Thread starter ovalandrover
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 58,170
- Location
- Preston Lancs.
Can be done. I take it the 22 is in a diesel and you want to fit a 24. You will need to fit the diesel torque converter and the bell housing and maybe also the oil pump to match the diesel torque converter drive.
ovalandrover
Well-Known Member
- Posts
- 1,632
I have just been to sussex automatics and they dont know if the oilways line up and also think the input shaft on the 24 is longer
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
you can interchange the parts from the 2 boxes ,but its a good few years since i did, iirc the pump housing is deeper on the 24 to take account of improver C/D clutch packs and a increase in plate for clutch pack A,input shafts just tap out
ovalandrover
Well-Known Member
- Posts
- 1,632
Apparently there are 3 different HP24 auto boxes fitted to the P38 and only the one with the number ending in 065 will take the diesel torque converter
- Posts
- 58,170
- Location
- Preston Lancs.
brianp38dse
Well-Known Member
- Posts
- 20,325
- Location
- heathrow
Didnt Datatec have all the details on swaping these boxes might be worth giveing him a pm, and tell him to come back as well its been a bit quiet on here lately
- Posts
- 2,101
- Location
- Mull of Kintyre
+1Didnt Datatec have all the details on swaping these boxes might be worth giveing him a pm, and tell him to come back as well its been a bit quiet on here lately
