I appreciate it’s quite an ask, but I’m desperate to get the measurement between the Xs in this pic where I’m holding a front anti roll bar bracket roughly where I think it will end up under my chassis.
The Land Rover handling pack manual kindly supplied by @norseman shows (2nd pic) how a paper template is used to drill holes, but without an actual template I can only use millimetres.
In the third pic I have sketched what I think I’m after, in case it helps.
Can anyone help?
PS - apologies in advance, I made a very similar post a week or so ago, but I realise I didn’t tag it, and this one is a little more specific.
The Land Rover handling pack manual kindly supplied by @norseman shows (2nd pic) how a paper template is used to drill holes, but without an actual template I can only use millimetres.
In the third pic I have sketched what I think I’m after, in case it helps.
Can anyone help?
PS - apologies in advance, I made a very similar post a week or so ago, but I realise I didn’t tag it, and this one is a little more specific.
