TheVengefulElephant
Well-Known Member
- Posts
- 6,527
Another one of these, am after a rough hestimut.
'88 E reg 110 CSW
stuff wots wrong wif it
;
I should find out and/or fix in the next few weeks, so if it is this that's wrong then its irrelevant, but I think the rings am gone, but I'll be replacing them.
Needs a new OSF outrigger welding on, I can do this also.
New front bumper, again I'll be sticking a brand spankers one on.
Side floorpan edging has corroded, not sure if its a MOT fail as its not the sill or a fixing point, but would just need a strip welding in.
8" section of box steel behind nearside panel behind passenger door corroded.
Will have two working wipers by the end of next week LOL
rear wiper mechanism FUBAR - needs new.
In need of 2 new doors really, but I have a set of all new hinges ready to go on.
Only one of the bench seats in the rear has seat belts, but as far as I'm aware they're not completely required on sideways facing seats? meh.
Ummm.. good points
err...
It's got four side steps and a foldy one on the rear?
It's a landy?
LOL ta.
'88 E reg 110 CSW
stuff wots wrong wif it
;I should find out and/or fix in the next few weeks, so if it is this that's wrong then its irrelevant, but I think the rings am gone, but I'll be replacing them.
Needs a new OSF outrigger welding on, I can do this also.
New front bumper, again I'll be sticking a brand spankers one on.
Side floorpan edging has corroded, not sure if its a MOT fail as its not the sill or a fixing point, but would just need a strip welding in.
8" section of box steel behind nearside panel behind passenger door corroded.
Will have two working wipers by the end of next week LOL
rear wiper mechanism FUBAR - needs new.
In need of 2 new doors really, but I have a set of all new hinges ready to go on.
Only one of the bench seats in the rear has seat belts, but as far as I'm aware they're not completely required on sideways facing seats? meh.
Ummm.. good points
err...
It's got four side steps and a foldy one on the rear?
It's a landy?
LOL ta.
