FIRE ONE
Member
- Posts
- 47
- Location
- Hitchin herts
Hi , going to do air to coil conversion , do I disconnect compressor and each height sensors wires then reprogram the ecu at a later date . Thanks Dave.
air to coil converion
- Thread starter FIRE ONE
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianconwy
Well-Known Member
- Posts
- 1,112
- Location
- conwy, north wales
I just changed the springs and then changed the ecu setting to coils. My compressor wasn't working anyway. I haven't disconnected the sensors. Haven't had any ill effects.
FIRE ONE
Member
- Posts
- 47
- Location
- Hitchin herts
thanks ,what device did you use, was is a simple to do
brianconwy
Well-Known Member
- Posts
- 1,112
- Location
- conwy, north wales
I used the lynx I have and it was very simple but to be honest I don't think it would have made much difference anyway.
sierrafery
Well-Known Member
- Posts
- 17,199
- Location
- Arad/Romania
The difference is that if it's converted to coils and not set to coils in the SLABS there will be continuous SLS error warning and a certain parasitic battery drain
