hi our Range Rover front suspension went down didnt come up in dash as inactive and do nit drive o er 30mph, hubby plugged in on lynx diagnostic machine didn't bring any particular fault up replaced r/h height sensor as was worn replygged in cleared that fault said hold button inactive replaced still not putting up front suspension pump working as back going up, replaced suspension ecu still no different hubby pulling hair out any ideas.
Air suspension problem on Range Rover l322 2002
- Thread starter Thatter
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 45,018
- Location
- Near Poitiers SW France
Leaking airspring?
philip pickard
Active Member
- Posts
- 239
- Location
- doncaster
valve block maybe blocked..or change the other side height sensor so both front sensors are changed then look at the valve block. the one just after the air cylinder,
Last edited:
- Posts
- 16,479
If Lynx is giving such unhelpful code information, then maybe getting it plugged in to some more powerful diagnostics could provide a clue.
I am also with Datatek - check the Air Springs.
Also, Ensure the tank has a full charge of air - run the car with a door open for 10 minutes to allow the compressor to fill the air tank, then close the door and select a ride height - then see what happens. Remember the car will raise the rear before the front to prevent the lights dazzling on-comers if the front goes up first!
I am also with Datatek - check the Air Springs.
Also, Ensure the tank has a full charge of air - run the car with a door open for 10 minutes to allow the compressor to fill the air tank, then close the door and select a ride height - then see what happens. Remember the car will raise the rear before the front to prevent the lights dazzling on-comers if the front goes up first!
