InTheHighlands
New Member
- Posts
- 8
I was brave and lent my TD5 Discovery to my wife; it came back with the ABS warning lights on - and the rear brake lights flickering on / staying on at random.
Reached for my barely used Nanocom Evolution2 and reset the ABS - think it mentioned a main unit problem, unlike a previous wheel sensor.
Went into the SLS module to look at ride heights as the car has always appeared a bit squint to me. I must have inadvertantly done something as the car suddenly let itself dow. Since then I've tried in vain to rectify....
Can easily pump the 2 sides up and have tried to save the ride height both by storing settings and by writing - per following instructions I found on another site :
I had exactly the same with my new Evo. After a few days I found the answer.
With the ignition on
1. Go to DiscoveryII*
2. SLABS
3. Scroll to page 2 and Go to Utility
4. SLS HEIGHT CALIBRATION
5. Raise left and right to the desired height.
6. DO NOT STORE HEIGHTS*
7. Click the X 3 times
8. SLABS
9. SETTING
10 Scroll to next page
11. Check left and right stored heights are similar and WRITE SETTINGS
12. turn ignition off as it instructs.
13. Do not touch anything for 60 seconds as it says.
14. click OK
Hopefully switch engine on - no fault light - car stays up.
On turning the ignition off, the car holds it's height for a couple of minutes, then lowers itself down to the stops.
I don't think it's a leak (unless it's somewhere that is initially shut off) and the car seems to do it quite deliberately.
Would REALLY appreciate any help or ideas.....
Thank
InTheHighlands
Reached for my barely used Nanocom Evolution2 and reset the ABS - think it mentioned a main unit problem, unlike a previous wheel sensor.
Went into the SLS module to look at ride heights as the car has always appeared a bit squint to me. I must have inadvertantly done something as the car suddenly let itself dow. Since then I've tried in vain to rectify....
Can easily pump the 2 sides up and have tried to save the ride height both by storing settings and by writing - per following instructions I found on another site :
I had exactly the same with my new Evo. After a few days I found the answer.
With the ignition on
1. Go to DiscoveryII*
2. SLABS
3. Scroll to page 2 and Go to Utility
4. SLS HEIGHT CALIBRATION
5. Raise left and right to the desired height.
6. DO NOT STORE HEIGHTS*
7. Click the X 3 times
8. SLABS
9. SETTING
10 Scroll to next page
11. Check left and right stored heights are similar and WRITE SETTINGS
12. turn ignition off as it instructs.
13. Do not touch anything for 60 seconds as it says.
14. click OK
Hopefully switch engine on - no fault light - car stays up.
On turning the ignition off, the car holds it's height for a couple of minutes, then lowers itself down to the stops.
I don't think it's a leak (unless it's somewhere that is initially shut off) and the car seems to do it quite deliberately.
Would REALLY appreciate any help or ideas.....
Thank
InTheHighlands
