Rezz
New Member
- Posts
- 115
- Location
- County Durham
One of my headlights is a bit "boss eyed" and needs lowering a little to match the other side. I have the facelift model and wondered if anyone can tell me how to adjust them? 
Adjusting dipped beam level..
- Thread starter Rezz
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brian47
Well-Known Member
- Posts
- 8,867
Open the bonnet and looking at the top of the headlamp unit, there should be two holes about half an inch diameter just behind the plastic fitting with what look like little cogwheels under them.
One of the holes will adjust the up and down and the other left and right, the inboard one sets the vertical and the outboard one sets the horizontal.
You'll need to use a flat blade screwdriver to move the little wheels.
Before you start adjusting the lights, make sure that the entire unit is properly seated, the whole unit has to be removed just to change a bulb.
One of the holes will adjust the up and down and the other left and right, the inboard one sets the vertical and the outboard one sets the horizontal.
You'll need to use a flat blade screwdriver to move the little wheels.
Before you start adjusting the lights, make sure that the entire unit is properly seated, the whole unit has to be removed just to change a bulb.
Rezz
New Member
- Posts
- 115
- Location
- County Durham
Similar threads
