androver
Active Member
- Posts
- 256
- Location
- Taunton, Somerset
Only able to wash drivers window, fine for me but not so good for passengers. Hoping someone knows the easiest way to get to the pipes. 
Access to window washer pipes.
- Thread starter androver
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
androver
Active Member
- Posts
- 256
- Location
- Taunton, Somerset
Who knows the best hard way then?
martin1512
Well-Known Member
- Posts
- 3,941
- Location
- Half way up a cliff in Dorset
You have to remove the padded shelf from on top of the dash, and slide your hand down behind the dash. Just below the bottom of the screen, you will feel the nut holding the washer jet on. If your hands are small enough, you can use a spanner to undo it. I had to clamp a pair of large molegrips onto the outside of the washer jet to stop it rotating with the nut. If you can't get your hands onto the nut, you will probably have to move the whole dash away from the bulkhead.
androver
Active Member
- Posts
- 256
- Location
- Taunton, Somerset
Not fixed yet but while behind the dash found the cards from the factory covering the individual requirements for the vehicle. Requests for electric washers being one. Also for hardtop in colour sand. Has highlighted how original my landy is. This is dated 6 sept 72.
- Posts
- 7,332
- Location
- Under my landy
V8jon
Well-Known Member
- Posts
- 1,439
- Location
- Pembrokeshire west Wales
I used to keep a small safety pin (stuck into the top of the dash) so when the jets get blocked just put the pin in the little hole in the jet from ouside and poke/prod and waggle it til the **** came out. How's that for easy?
androver
Active Member
- Posts
- 256
- Location
- Taunton, Somerset
Very easy and that is what I have done. Although need to do it again as drivers side has stopped working now!
V8jon
Well-Known Member
- Posts
- 1,439
- Location
- Pembrokeshire west Wales
