After I reconnected two abs wires, then start engine, other lights are gone but abs. When I unplugged two abs wires and started engine, I saw three amigos, they are original wheel hubs. Do I to turn off it with Nanocom or drive a while? Your ideas are appreciated greatly
Disco 2 ABS stays bright after two abs hub wires are reconnected
- Thread starter Kaijun
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
. I saw a green light first time. I was panic for tomorrow mot retest, then surprising, all lights were gone.
steve24v
Well-Known Member
- Posts
- 537
- Location
- Romsey Hampshire
I did the same over the weekend, abs light stayed on. I turned it off with my nanocom. Not sure if driving it will turn the light off
JUKE179r
Well-Known Member
- Posts
- 3,165
- Location
- Suffolkshire
Clear the codes and then drive her for a bit.
- Posts
- 41,244
- Location
- East Dorset
If it's the same as a Disco 2 the car needs to be moving at I think 8 mph before they'll go off. Presumably as a fail-safe check to be sure the fault has actually been fixed.
