6th & 7th seat fitment?

hi there,

just bought a 300tdi, the bloke that had it last had taken the rear bench and 6,7th seats out as he was using it as a van. i have fitted the bench seat but cant see how the 6,7th seats fit in, i have all the brackets but its not obvious where everything goes. does anyone have a diagram or photos of how everything goes together? thanks in advance.

No photos but all the bolt holes/fixings are there as standard, you may have to make holes in the panels if the vehicle has never had the jump seats fitted.

there are holes there and some have been covered with interior coloured vinal stickers. if i could see a photo of the seat folded up and down i should be able to work it out but there are a shed load of brackets, and it just doesnt look obvious where they go. cheers though.

The plastic panel pops out and you fix it in where the rear lights are then put the panel back over

i will rip the panel off and check it out, thanks. any ideas where i can get the lap belts for these seats?

You need to fit brackets with the side interior panel out and also fit / bolt the seat belts in place. Then thread brackets and seatbelts through the holes in the interior panel before cliping this back into place.
As disco ben says, there are lots of holes some covered and some not - make sure you seal up the holes you don't use.
If you post some pics I may be able to help as I did this last month.

sorted the seats, thanks for the help. now just need some belts. cheers