sws0168
New Member
- Posts
- 71
- Location
- North Wales.
Got a gearbox / transfer box, fitted and drives ok but one problem the gearstick is hitting the handbrake when going into reverse, bent gearstick ?, or any ideas.
Thanks
Thanks
380 gearbox
- Thread starter sws0168
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
if you remove gaiter there a 13mm spanner sized bolt you can turn stick a bit if you loosen it
sws0168
New Member
- Posts
- 71
- Location
- North Wales.
Hi, The stick seems to be leaning toward the drivers side, and not upright as the other one was, i need a diagram of how the stick fits in the box, maybe its not seating right or maybe bent, my disco is a 94. 300. the box is out of an S reg. 300.
sp33der
New Member
- Posts
- 372
Like James said and also check the bias plate or the springs maybe?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
gear sticki is in two halves top unbolts using pinch bolt ,bottom goes through top into selector yoke ,its possible either are bent but be careful bending lower shaft as you might break off inside part of shaft
sws0168
New Member
- Posts
- 71
- Location
- North Wales.
ok thanks, will reply when i find out what it is.anyone got a diagram of the box ?, and can i change the lower stick form my old box.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
remove consol and drill out rivets and 2 x screw on cover
sws0168
New Member
- Posts
- 71
- Location
- North Wales.
ok thanks will have a go.
Similar threads
