300tdi bakes can not get a pedal help please..

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

gazzzza

New Member
Posts
8
Location
NORTH EAST
hi i have repiped the full system and can not get a pedal.
i have changed the servo and compensator and still no good, can you give me some ideas. :(:confused: The pedal just gos to the floor..
 
I always preferred to pressure bleed brakes. It stopped all that pumping and stroking the master cylinder past it's normal movement. If you can beg a pressure bleeeder then I'd start there. Otherwise. I would try and get some fluid past the mater seals by bleeding some out at the master cylinder unions and then following it down the line.
 
I always preferred to pressure bleed brakes. It stopped all that pumping and stroking the master cylinder past it's normal movement. If you can beg a pressure bleeeder then I'd start there. Otherwise. I would try and get some fluid past the mater seals by bleeding some out at the master cylinder unions and then following it down the line.
hi tricky i have done that m8 got fluid to all brakes with pressure bleeder, i have blanked off the front, and the pedal go's hard but when i put it back in the pedal go's to the floor, do you think i have done the seals in on the master cylinder, but i have had it all apart and looks ok , this has got me head done in..:confused:
 
does res have splashig or bubbles in when pumping pedal as is sure sign of master cylinder seals,master has two sets of seals with part nearest servo working front brakes and forward part operating back ,i would fit new master cylinder
 
does res have splashig or bubbles in when pumping pedal as is sure sign of master cylinder seals,master has two sets of seals with part nearest servo working front brakes and forward part operating back ,i would fit new master cylinder
thanks james for that m8 will be letting you no 2mora.
 
Back
Top