Disco 1 300 rear bumper onto 200tdi - Is wiring the lights a MOT requirement?
- Thread starter Baker556
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 45,086
- Location
- East Dorset
If in doubt, take them out just for the MOT. As long as it has all the necessary working lights it shouldn't fail just cos it has some other holes in the bumper.
Alternatively, wire them in to the existing loom.
Best of luck!
Alternatively, wire them in to the existing loom.
Best of luck!
Thing is, if you remove them for the MOT there is a gaping hole in the bumper where something is meant to be right?
I did think about just sticking black duck tape over them to hide for the MOT, but then whoever is doing the MOT might become suspicious - I don't want to hide or cover up something.
It's catch 22 really - I guess I could wire them up :/
I did think about just sticking black duck tape over them to hide for the MOT, but then whoever is doing the MOT might become suspicious - I don't want to hide or cover up something.
It's catch 22 really - I guess I could wire them up :/
Hicap phill
Well-Known Member
- Posts
- 16,337
- Location
- Wiltshire
If they are well covered with tape mot person cannot say anything. They can’t remove the tape either
- Posts
- 45,086
- Location
- East Dorset
Really can't see the issue.
The holes could only be a problem if they had sharp edges or summat which could hurt a pedestrian.
The holes could only be a problem if they had sharp edges or summat which could hurt a pedestrian.
