darrenm
Active Member
- Posts
- 670
- Location
- Chorley Lancashire
My reverse sensors have stopped working the dash switch is flashing but don't get any bleepIng has anyone got any idea
2004 disco 2 reverse sensors not working
- Thread starter darrenm
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Bromsgrove Defender
Well-Known Member
- Posts
- 5,759
- Location
- Out to lunch
You could check the wiring to the sounder....
failing that tie two small animals to your rear bumper and when they squeal.... STOP!
failing that tie two small animals to your rear bumper and when they squeal.... STOP!
666 george
Well-Known Member
- Posts
- 1,535
- Location
- Essex
You could use your eyes to see where you are going !
Bromsgrove Defender
Well-Known Member
- Posts
- 5,759
- Location
- Out to lunch
darrenm
Active Member
- Posts
- 670
- Location
- Chorley Lancashire
Haha very funny
darrenm
Active Member
- Posts
- 670
- Location
- Chorley Lancashire
I think the problem is the buzzer as the sensors are working but cannot get the buzzer to make any noise
darrenm
Active Member
- Posts
- 670
- Location
- Chorley Lancashire
Iv changed buzzer it now sounds shame it just makes a constant noise
Bromsgrove Defender
Well-Known Member
- Posts
- 5,759
- Location
- Out to lunch
You could check the wiring to the sounder....
failing that tie two small animals to your rear bumper and when they squeal.... STOP!
Have you removed the two small animals that were attached in the interim
Could be a dodgy sensor.
I dont know whether they close or open circuit when activated.
I'd recommend using a multimeter to see what's going on
