pat murphy
Active Member
- Posts
- 342
Can somebody tell me how much engine oil with filter change a 2,5 na ex military holds please
2,5 na
- Thread starter pat murphy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Marmaduke
Well-Known Member
- Posts
- 9,773
- Location
- Near the land of 'Me Duck'
According to Haynes the sump capacity(drain and refill, excluding oil filter) is 6 litres, so I'd start with that and check on the dipstick after running for a couple of minutes
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Think with the filter it's another half a litre.
Just put in 6 litres and wait for a bit see where it gets to on the dipstick, idle it for a bit, recheck level then top up accordingly carefully till its at the right level, small amounts at a time waiting and checking between each top up. If replacing the filter put some fresh oil in the new one before screwing on, subtract this from the amount you are putting in
Just put in 6 litres and wait for a bit see where it gets to on the dipstick, idle it for a bit, recheck level then top up accordingly carefully till its at the right level, small amounts at a time waiting and checking between each top up. If replacing the filter put some fresh oil in the new one before screwing on, subtract this from the amount you are putting in
Last edited:
dieselmonkey
Member
- Posts
- 64
I'd put just shy of 6 in, run it check level then top up to just below the max. These engines don't take kindly to being overfilled.
