1995 P38 Sunroof Reset

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

stevef1964

Active Member
Posts
298
Location
Horley, Surrey
Hi all,

I've been trying to reset the sunroof because of the "Sunroof not set" message on the dash.

Have tried this method:

Open fully and hold for 5 seconds, close fully and hold for 5 seconds, tilt open for 5 seconds and then close tilt and hold for 5 seconds.

At some point during this process the "Sunroof not set message does disappear, is this correct?

Also, to get the sunroof to tilt open during the above process, I have to slightly release the button before re-engaging it.

Once I have gone through the process the dash message disappears only to appear again when I operate the sunroof.

Is there something I am doing wrong?

Is there something else I can try?

Thanks in advance

Steve
 
When closing the sunroof, I cannot get the the tilt to work unless I release the button slightly.

If I keep my finger on the button the tilt operation will not start.

I am waiting 5 seconds. should I wait longer?

Should the tile operation start whilst I have the button pushed down from closing the roof?

Could the button be faulty or need a clean?

Is is me!!!!

Steve
 
You will get a sunroof set message when its done it. You do need to release slightly to get from slide to tilt. Check around the seal to see it there is anything preventing it from fully opening or closing. just keep trying its female afterall it will only do it if it wants to.
 
I reset mine without waiting for the 5 seconds ... ie. open up full and as soon as fully open close it then do the same for tilt. That seemed to work fine.
 
Back
Top