ericthered
New Member
- Posts
- 107
- Location
- county durham
I have been told that to change one of these bulbs ,its the back door panel off , there are 2 screws in the covers which are heavily rusted ,is it just a case of taking these out .
ETR
ETR
1995 disco tdi300 numberplate light
- Thread starter ericthered
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
janderson41
Active Member
- Posts
- 442
- Location
- Howwood Renfrewshire
According to Haynes all you do is loosen the two screws,lift out the light unit, then remove bulb and replace with new.Give the screws a good dose of wd40first. Replace with new or even self tappers.
cheers
jim Anderson
1996 300Tdi auto(Jap reimport)
cheers
jim Anderson
1996 300Tdi auto(Jap reimport)
SHORT ROUND
Active Member
- Posts
- 675
- Location
- forest of dean, gloucestershire
drill out the 2 screws mate normally 2 min job but with drilling and changing screws may take 10-15 mins
ericthered
New Member
- Posts
- 107
- Location
- county durham
thanks for that lads didnt fancy going in through the back door .:doh:
Similar threads
