04 110 XS TD5 ABS Fault

bankz5152 · Dec 18, 2019

Rather annoying i seem to have a frequent front ABS fault.

Ive changed the sensor 4 times in 2 years always front right. Nanocom reads -

Front right sensor output too low - intermitent 16 times

Usually only crops up 3 or 4 times a year but recently coming on daily have having to reset it.

Reluctant to buy another sensor (intermotor, cant find Wabco for nom silly money)

Could there be a fault elsewhere im not checking? As far as I know it is fully seated.

brianp38dse · Dec 18, 2019

have you had a good look at the ring on the shaft it reads from they have been known to crack .

DanClarke · Dec 18, 2019

Mine was fully seated and nothing wrong with my reluctor ring I could not see anything wrong with the transducer itself at all (comparing new Vs. Old) but the copper coloured sleeve it sits in was shot and all corroded away I think it was misaligned somehow.
Anyway I changed the whole lot just to be sure and fault was gone.

mikegsxr · Dec 18, 2019

Excess slack in the CV joint was the cause of my ABS/TC faults and odd drive noises. Replaced with britpart CVs and still going fine...
I think the wear allowed the outer cup (with the wheel speed notches on it) to flap about. Pulled the suspect one
apart and it didn't look that bad.

bankz5152 · Dec 19, 2019

Hmmm interesting. Ill look into the CV

retneprac · Dec 23, 2019

Mine was playing up, turned out to be the top swivel pin worn away. new pin and bearings, sorted.

bankz5152 · Dec 23, 2019

retneprac said:
Mine was playing up, turned out to be the top swivel pin worn away. new pin and bearings, sorted.

Possible though they where changes 25k ago, that said not had an easy life since...

04 110 XS TD5 ABS Fault

bankz5152

Well-Known Member

brianp38dse

Well-Known Member

DanClarke

Well-Known Member

mikegsxr

Active Member

bankz5152

Well-Known Member

retneprac

Well-Known Member

bankz5152

Well-Known Member

Similar threads