P38A [P38] Common coolant leak locations

[blue_cheese]

You did put the o-rings onto the pipes didn't you before fitting?

I did! They're on there somewhere, 11 quid from the main dealer

You can magnetise your screwdriver tip with a magnet!

I tried this with a fridge magnet, but I think it was too weak, the magnetisation was pathetic. Think I'll make a trip to Screwfix

 

[Grrrrrr]

I did! They're on there somewhere, 11 quid from the main dealer

I tried this with a fridge magnet, but I think it was too weak, the magnetisation was pathetic. Think I'll make a trip to Screwfix

Got a speaker anywhere?

 

[Mark Piercy]

I did! They're on there somewhere, 11 quid from the main dealer

I tried this with a fridge magnet, but I think it was too weak, the magnetisation was pathetic. Think I'll make a trip to Screwfix

Is there anything to lube the
o-rings, they are very resistant pushed in dry... Nod nod

 

[blue_cheese]

Is there anything to lube the
o-rings, they are very resistant pushed in dry... Nod nod

I have copper grease, or is silicon better?
Also, are the O rings supposed to fit snug in to the matrix? Right now the pipes slot in but they don't go in much and have little resistance

 

[Mark Piercy]

Not copper grease my mate and only if its silicon grease not sealer! , you don't have any other grease to wet the oring outer surface which will allow them to slide in while fitted on the pipe end?