P38A Help ??????

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Got one of the four hub bolts stuck fast it's a 15 mill that's been rounded off so heated up and banged on a a/f size a 14mm wouldn't go on it I've sprayed it with release lube will leave it overnight any more suggestions as to getting poxy thing out much appreciated
Irwin sockets!
 
Cheers mark that's what I've hammered on to it 9/16 but just a normal socket I've not got any Irwin sockets guess they have to go on the shopping list
 
Got the last bolt loose came out fairly easily after the overnight soaking in release stuff next ones the hub nut that's stuck tight so leaving it soak aswell but will still get them Irwin sockets for next problem bolts
 
Got it all off now for the next problem the offside seemed to come apart easy but how do I separate this from the driveshaft
 

Attachments

  • IMG_0565.JPG
    IMG_0565.JPG
    321.4 KB · Views: 56
  • IMG_0566.JPG
    IMG_0566.JPG
    324.1 KB · Views: 72
That's what I thought I was trying to rember how the other side came off so best to pull it all out and give it a tap
 
Poxy predictive tx KDS cheers also that big metal washer that goes on the end of the axle in front of the seal is that supposed to come of as I wanted to replace both seals and them metal washers
 
Got both sides stripped down and cleaned off now what I have noticed is one side moves quiet easily the other is stiffer any suggestions much appreciated hopefully not ball joints related as have no press
 
No the ball joints no movement in them but when turning each carrier thing nearside easy offside harder
 

Attachments

  • IMG_0556.JPG
    IMG_0556.JPG
    323.7 KB · Views: 67
Back
Top