Gave owned a disco 3 for 8 years without suspension problems() air suspension began leaking and replaced the front suspension units. As the compressor has been making loud noises replaced that as well. The amber light now comes on with fault that temperature is too high in the new compressor. Any good tips??
Disco 3 suspension
- Thread starter step-pal
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
welcome to the asylum
does it drop overnight , any leaks anywhere
overheating may be down to a leak somewhere and causing the compressor to try and keep up
what codes come up , was the relay and software updated when the compressor was replaced
may even have a faulty compressor ??
but let's start with the easy bits first then got from there and help u all i can
gary
Thanks!
It doesn't sink overnight. Have got over everything with soap water and no leaks. Relay changed but haven't updated software. Didn't think about that. Only fault code that comes up is u 2000. The pressure at tank is about 12 bar. Use a bearmach to find the codes.
how old is the compressor , have u changed makes, i.e. gone from a hitachi to amk
if so will need the software to be updated
when u turn the engine off , do u hear a hiss, of the compressor relief valve operating
looking at the instrument panel, does it operate the 3 x different levels, access , normal and off road
u will see a small arrow in the display , this should go out at each level
if it doesn't it would indicate the levels are incorrect
get it plugged in first , make sure the software has been updated , can then go from there step by step
hope that helps a little
Ok,will start with a sofrware update and see what happens. Thanks for your time
