cheers palThey are very easy to fit . the special hook bolts go into holes on the inner side of sills that have a tape over them . You position them using the short slightly angled attatchment projecting bar , then when you look underneath you will see where the inner edge of the mounting bars press against chanl sections of underside Hope that makes sense Its about a ten minute job each side
ps they fit both 3 and 5 door models the u sections go against bottom edge of sill lip , the bolts go thru the washers with holed welded to those square tubes .
its is also for looks not just a stepWhy the feck do you need a step to get in a freelander
lined them up ok but can not work out the brackets that came with runnersSorry no took them off my 3 door
the taper of the step faces towards the front , and the thing prettywell lines itself up , get it uder vehicle and laydown and you will soon work out how it positions .
It helps protect against car doors opening and causing side damage
u mean it helps stop the doors falling off?? cheers now sortedThey look okay to me , the hooked end goes in to the holes in sills and the trhreaded rod hangs vertically down and you lift the steps up to them . They are held horizontal with the open side upwards to go in the holes and the part at rightangles to thread rod goes onto bottom edge of hole
Welcome To LandyZone, the Land Rover Forums!
Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.
Registering is free and easy just click here, we hope to see you on the forums soon!
