Search results

hi, had a bosch external high pressure fuel pump, its gone plop so any recommendations for a replacement?

Hi, I have a rover 3.9 efi V8 from a 1994 disco with a blown head gasket. I know it is blown, due to compression tests, water coming out the exhaust, coolant under pressure etc. But was wondering if it could be causing the flooding issue I have been experiencing? Every time I try and start...

Hi, its a 3.9 efi v8 from a 96 disco now in my comping truck. I have had sooo many problems with it i don't no were to begin! took the car to a pay and play the other day, it overheated. mind you the engine was not properly timed, although it was there or there about. I put some engine fans...

Hi, my 3.9 v8 efi from a 96 disco takes a very long time to start, and will usualy not go from cold until it has oil pressure (about 8 seconds of cranking) and then i switch on the fuel pump or it floods and it will go. It runs good when going though. any ideas? :confused::confused:

Hi, swapping from abs to non abs brakes on my racer, it had abs, just wandering if the rear calpiers are the same for abs as non abs calipers? (92 3.9 efi by the way) thanks in advance Oak Richardson

Hi, Swapped the V8 in my truck from a 92 3.9 efi from the range rover to a 96 disco 3.9 serpentine efi one. The previous engine wouldn't run but it had done 200,000 miles and the serp one had done half that and i knew it runs so i swapped that in. The problem before hand was that it just kept...

Hi, I have a rover 3.9 efi v8 out of a 92 range rover classic. The thing is in my racer, and the other day I damaged the exhaust silencer so I decided to change it for a spare 3.9 v8 disco silencer. I did this and it initially went well. It smoked a bit more then usual though and after a...

Hi, Would swapping a 10 spline range rover axle to a discovery 24 spline axle mean the gearing needed to be changed at the front? Or is this a simple swap? Regards Oak Richardson