Search results

Its been back on the road for a month since it's rebuild and I use it everyday about 3 miles to work but choke is in before I get to work. On further investigation the carb seems to be sucking in air and also had some crap in the top. This has been my first re-build and also the carb/ignition...

Sorry I should have said Land Rover has been completely rebuilt, new plugs, leads ,dizzie,rotor . Battery turns over fine and have checked for air in lines. Possibly some muck in the carb?

My s3 had trouble starting at 7 this morning , turned over fine with full choke but very reluctent to start, it was about 5 c at the time . Have had some trouble with pre-ignition or running on after turning off and starting fine one minute but not the next. It always starts eventually. It has...

no noise while depressing clutch only when releasing at biting point

M 1974 series 3 has been on the road now for a month since it's rebuild. After about a week I started to get a screeching noise at biting point but only from a standstill. I thought it must be thrust bearing which I didn't replace during rebuild as was fine beforehand (I did replace clutch...

I wouldn't buy any britpart brake components , I had huge problems with an overhaul kit the shoes were awful I put the old shoes on to get through MOT . Also a s/s exhaust from Paddocks went back 3 times before it fitted together properly.

Hello everyone I'm delighted to be back on the road after a years re-build just in time for a cold morning and a wet roof. I've always put up with it in the past but just wondered if any of you clever chaps had any ideas to overcome it ,say with some sort of lining?

Luckily I kept the old ones which I put on the front and proved good enough to finally get a ticket. So after nearly a year off the road a galvanised chassis and a full mechanical re-build, we're back oin the road:)

I'm sure I got mine from paddocks, ring them up and ask them.

I would say about an inch at each end, and when they touch i think it then flexes adding to the problem. I have purchased various Britpart parts and I know they are reasonably priced, but that dosen't mean they shouldn't work.

I've used new Goodrich hoses with new brake pipes and a new master cylinder which I will have a close look at regarding the bore, thanks for that

Hello I wonder if anyone could help, I've just finished building my series III 88" and put it in for it's MOT . Everything was fine but it failed on the brakes binding. Apart from the drums which I skimmed all components were new but I had great trouble getting a firm pedal without winding on...