Search results

northeast also

thats great thanks better to have a idea and couldnt find which was which in the haynes manual and seems all is where it should be again thanks

could anyone tell me what relay is for what on my 1989 land rover 90 i am counting 3 behind my fuse board and 3 behind my bininacle just wondered which was for what and struggling to find anywhere to tell me?

A thoughtful passer by made a call to international rescue in the guise of a nice fella willing to leave his arm chair on a saturday afternoon and crank up his 110 fitted with winch and come to my rescue luckly i had the sense to kill its engine before it drank the north sea so was able to fire...

some prat namely me dropped his landrover into sand upto and beyond its front bumper and had a bit of a bad day yetserday

thanks great looks like it will be a pay day job now then its worked out to be a dear do to change a cam belt just for peice of mind not knowing if or when it might have been changed but still cheaper than a engine swap worst case and better the devil ya know thanks again for all the help very...

thanks for the help its a 41mm bolt in the bottom pully do these anti rotation tools still fit and allow room for the socket to fit and achive full purchase?

i may need too didnt realise it would be that simple thanks

is there any alternative i should be trying before trying that have tried difflock engaged low ratio and 1st gear handbrake applied and just turning it with a extension on t-bar but just over powerd hand brake each time also tried impacting the socket while turning it did try a windy gun but its...

having a job removing the crankshaft pully bolt from my 19j engine to replace the cam belt before i put it on the road bought a 41mm socket and struggling to release the blot read somewhere to put a breaker bar under the chassis rail and put landy into low ratio 1st gear remove lead from stop...

My girlfriends parents disco 1 petrol v8 with lpg conversion starts cold no problem but when warm becomes unreliable and sometimes wont start at all until cold again so was wondering if it had a cold start valve or sensor that could be causing the problem its been on a landrover fault reader and...

my project 90 my rear offside chassis and rear cross member are shot along with door pillars both near side and off side and centre out riggers the pole type front of rear tub- back of diesel tank i have bought new door pillars new rear cross member with extensions and have 50mm pole to do the...

the clutch is in my 90 now she pulls well and selects every gear so thank you all for the input although a heavy job to do on my own at the end of the street but all done now so hopefully wont need doing again for a good while

it has turned out it is the clutch friction plate at fault the flywheel side been stripped completely the gear box and transfer box all seem fine and functioning as they should so thank you for all the info and not looking forward to lifting the transfer box back into place its a heavy bit of...

again thank you all for the information i should have the gear box removed and gear box and clutch inspected tomorrow if i am not working and will post the cause of its problem/problems as i find them

i know sorry guys i know its not a american toy my bad wont happen again

dont know just bought jeep as project friday been stood on a farm for 18 months so a bit of a mess at the min but almost everything is there for her so decided it would be a good base to start with but form what you said i am now suspecting the clutch either way i think the box out is my best...

thank you greatly that helps me undersatnd it a bit better. what is most likely to cause loss of drive althogether the engine is running great and feels like i can select all gear options, clutch peddle feels good and returns nicely but as i select a gear on the transfer lever there is a squeal...

again thanks for the help

cool thanks guys so whats my most common cause for loss of drive and does anyone know where i can access the imformation on the landrover system for the tranfer box diff lock and all its operating levers switches ?