Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. S

    Thermal Exhaust plate

    As title says..... Has anyone tried one of these plates. I thought they may help with manifold warp. They resist thermal transfer between the head and manifold lowering EGT. Thermal Inlet Gasket - Ferriday Engineering I know the link says inlet manifold, but they are available...
  2. S

    Disco TD5 Starting perfect, but cutting out when reved

    Could be your injector loom crapping out when you put load on it. Just replace it, they are cheap enough. Pull the red plug on the ecu and check the injector wires with a multimeter, between the red plug and the connector at the head. Also check for oil at the red plug as mentioned. Check...
  3. S

    m and s lights flashing wont turn over!

    The 1/4 will be fine mate, provided you've got the right socket size. I can't remember the size of the nut, off the top of my head it could be 15mm. Space is tight and you'll struggle with a 1/2,
  4. S

    Disco 2 Auto "hunting for gears"

    What speed was the cruise control set to maintain?
  5. S

    Nanocom to Diagnose Air Suspension Fault

    The slabs ecu self tests when you ignition on. It will even tell you if the earth to the ecu is bad etc. If you suspect the valve connectors are bad, unplug them one at a time and read the fault codes when you ignition on.
  6. S

    Nanocom to Diagnose Air Suspension Fault

    Go into slabs on nanocom, ignition on. Go into outputs sls and you can test left and right valve, exhaust valve and compressor. Stand outside vehicle and work through open drivers window, All doors shut
  7. S

    Leaky roof bars?

    Sounds like the leak is between the roof and the plastic frame of the sunroof. This is the joint that fails, not the seal between the glass and frame. Mask up and run a bead of sikaflex around the outside, where it meets the roof.
  8. S

    Nanocom to Diagnose Air Suspension Fault

    The car is sitting low due to a leak in one of the bags, so the bags definitely need inflating and the sensors appear to be working fine. Fix your leak first, before you burn your compressor out. A £60 fix or £60 + £250 for a new compressor.
  9. S

    m and s lights flashing wont turn over!

    On the link I gave you, there is a guide to fitting once the starter is off. There are two bolts and a nut holding the starter to the gearbox. The nut is hard to get at, but use a 3/8 ratchet, extension and knuckle down theback of the starter and you'll get it. You'll also have to remove the...
  10. S

    m and s lights flashing wont turn over!

    Could be a few things:- - Battery as mentioned. Although starting ten times, voltage will be down. - Solenoid on starter, easy and cheap fix, see here...
  11. S

    TD5 engine swap 10P to 15P - need help with coding injectors

    Injector codes, should not stop the engine running, just not rev over 3000 very well. Check main relay, crank sensor + wiring, fuel pump and regulator. They can be hard to get all the air out of fuel system, follow the purge procedure and repeat until pump quiet. Check discovery2.co.uk...
  12. S

    Injector Timing Marks

    Found the marks, which are behind the front sprocket. The highest point on each injector lobe is indicated by a line and and a reference number. The line lines up with the edge of the cam carrier. I've attached a picture, but it was tricky because of reflection. I hope you can make it out...
  13. S

    running problem

    "The pump gets louder and louder until it just gives up" I really suspect you need to do your injector washers and seals again. Sounds like your getting air in fuel from compression ie copper washers. Re do them yourself following the below link: www.discovery2.co.uk / TD5 Engine -...
  14. S

    wastegate valve

    Watch the video on the link below. If you can do this, your wastegate is fine. Checking wastegate on a TD5 - YouTube
  15. S

    Water Ingress headache - Passenger & Drivers footwell

    There are drain holes under the vehicle at the base of the A pillars. Check these are clear of crap or water can't escape. They are difficult to see, so a mirror and torch may help. Check fitment of scuttle at base of windscreen. If rubber is not hard up against the glass, water will get...
  16. S

    TD5 Auto transmission warning light

    Crawl under and follow the wires back from the xyz switch on the side of gearbox. You'll find 2 black female spade connectors. These are meant for a temp sensor on the transfer box, but on the auto the sensor is on the cooler under intercooler, so they are just left hanging. Check these spade...
  17. S

    Sunroof not working ?

    Unscrew the 8 or so screws on the trim above the drivers head and expose the motor. Check its getting a voltage. If voltage present remove motor, open it up, clean an re grease. You may have got some water in. Removing the trim also exposes the sunroof ecu for check or replacement. Its only...
  18. S

    td5 turbo does not kick in

    How much water? Did you hydrolock?
  19. S

    Turn Over Problems

    Have you purged fuel system after checking fuel pipes? Check main relay is working. What engine work have you done to vehicle?
  20. S

    Sunroof not working ?

    Check settings in BCU also. I stripped my fuse box due to oil in it, and on powering back up it thought it was a v8 manual instead of a td5 auto.
Back
Top