Search results

Well , having removed the heater unit we discovered the fan was working after all when connected to a 12v battery, but not when connected on the loom. Question was what was causing that problem. We checked all the connections for continuity and they seemed ok. I removed the glass fuse to check...

Hello All and Happy New Year 2023, I know it's been a while since I was on and needless to say she's had a few changes and upgrades since, anyway and hopefully I can get some help. I have to replace my heater motor 'coz I sure aint drivin around in this cold without heat, so I just can\t...

Hadn't thought of that, thanks for the tip

or maybe it is the ps pump on the plate with the alt above !!!

they are great to have, thanks I am working towards putting the alternator as in yours , but I did wonder about the ps pump I may not have room there as there are pipes in situ, but then again !!! is the pale thaqt the alternator is on a part or did you make it ?

Because if cool water is not being pumped around the head gets hot !!

Rhis mornings update So i turned the switch, i didnt start her, just turned on ignition and noted zero temperature. Then i left her on for an hour and when i checked back still zero. So i guess i can discount temperature sender as the problem. So now I'm deffo thinking its a pump problem, why or...

Thanks for those. I did think i might try the alternator up there but i will have to look at the mounting of the ps pump too i have been gathering photos from various other places and trying to decide what bit and pieces i need to make it happen Am getting there, albeit slowly ;-)

Yes, it's a 1993 ex Disco 200tdi It was fine up to a couple of weeks ago, then wasn't move ontil a couple of days ago and this happened It always had a high reading on the temperature gauge so i had inserted a 120ohm resistor is series and that worked fine. Then recently i decided the Steve...

Thanks for that Tottot, Yes I think I may be able to move the alternator up and forward and then i hope to try move the ps pump back and as you say on it's own short bwlt time will tell, lot's done, more to do.

Thank you for the replies, Indeed I did suspect the sender and wiring, so today I replaced the sender (Steve Parker one) and replaced a good length of the cable. The old one was a rather haphazzard affair done by someone previously just added apiece with twisted connection. I added fresh cable...

Well maybe it's not erratic, but I am mystified as to why the gauge is nearly in the red when i turn the ignition on. I have checked the earth from the battery and it's well earthed. There doesn't seem to be any problem on the wiring to the gauges ie the clock is running fine and it uses the...

Hello, as the heading says that's the plan, however.... I thought it might be a good idea to use Defender 200tdi inlet & exhaust manifolds to get over that upper exhaust pipe problem.....it wasn't... Because now I have a very slippery belt setup on power steering pump. Ideally I will have to...

Much appreciated, thanks.

Thanks for that info, I now know what I am looking for at least Hopefully, weather permitting, I will get going on it later

Hello, I need a bit of help here... 200tdi fitted a few years ago and I have recently realised I have a Difflock Indicator problem - the cable missing apparently Could someone tell me where the cable goes from the transfer box switch, ie does it run up towards the front of the bulkhead and into...

Hello, just wonder if anyone has ever had this problem. While driving yesterday the speedo and rev counters started to fluctuate erratically and finally stopped working. Fuse no 14 on the main panel was blown. replacement also. I removed the instruments and new fuse blows. Can the speed sensor/...