Search results

As title, my 3.9 v8 Disco has just used over a quarter of a tank on a short drive. Vehicle has steve heath fault code reader fitted and a mark adams tornado chip which means the engine management light actually works. But i got no fault code on the reader and no engine light on. The...

The locals told us it was shallow! - YouTube Luckily we managed to get him out the cab!!

As title, just wondering what sort of oil pressure people are getting from the v8's?

Vehicle 1996 Disco V8 R380 Manual. Ashcroft one piece transfer box diff pin, ashcroft lsd diff in front and kaiser locker in the rear. As per title, was out offroading today when going up a 2nd gear hill i had to stop and reverser down. as i came down in reverse i notice there wasn't any...

Just a quick one to see if anyone has any ideas. 1997 3.9v8 all running well then all of a sudden stalled and wouldn't restart. Finally started but with a nasty misfire throughout the rev range, hot or cold. Checked everything like coolant temp sens, maf readings, tps, timing...when checking...

Mates got a disco of a fine 1990 vintage with a 3.5 running petrol an on lpg. It's started to run super duper black smokin' rich! And has a small missfire. So far swapped the coolant temp sensor m.a.f tps checked timing fuel pressure regulator plugs and leads... ...it's running richer...

Afternoon diesel fans!! My mates 200tdi is pretty damn slow, slower than it should be. Also tends to cut out if you blip the throttle or sometimes when you dip the clutch to change gear, any ideas? Im not up in my diesels but could it be the lift pump?

Any ideas if there's a bigger rad that will fit into a disco 1 v8 manual?!

As title suggests does anyone know what size the bolt heads are that hold the a frame to the chassis, not the ball joint end. Mine are all crusty and want to use the right size 1st time

A while ago i posted about my 97 disco 3.9 v8 not revving past 3500rpm when hot. Since then it has been to 3 different garages and none of the could find any fault. I have bout and used a steve heath diagnostic tool which only once has shown code 48, stepper motor/intake air leak/ base idle...

My friends... Yes my friends not mine 1992 disco 200tdi won't rev past roughly 2500rpm. Check the pipe from turbo to diesel pump and couldn't see and splits. Removed the pump diaphragm and again no splits. This is about as far as my knowledge on these goes so any help would be appreciated!!

As the title suggests, how can you check and if needed set the throttle butterfly? 97 Disco 3.9v8

Evening/afternoon/morning all! New member on here, put a few posts up and hopefully some helpful replies. Drive a 97 V8 Disco so i'm constantly skint. If i'm not driving it i'm under it fixing it being skint an dirty!!