Search results

Yes, that is what my scanner says. What repairs are required to resolve the misfire codes? thank you

Actually, after sitting for 30 minutes or so with the ignition turned off - the Check Engine Light goes out. Plugs are clean, no oil or water visible. No water in the oil in the engine, no oil in the coolant. Engine runs quite and STRONG. I don't think it has any problems with compression...

Hello, I have a 2003 Freelander KV6 Petrol. I am getting P0306, P0304, P0301, etc. 78,000 miles. After resetting the codes, it starts and runs fine for 5 to 10 minutes. Then when accelerating away from a stop it throws the errors. At the same time the Fuel Status on my scanner changes to...

Just a final note on this project. I found out the the "noise" was the two rear timing belts slapping on their covers. Once I replaced both with new belts (now all four belts have been replaced with new), the car sounds like new and runs great! I've put several hundred miles on it now, since...

I have completed the head rebuild on the KV6. I purchased the Laser 4577 Timing Tool Kit off ebay/uk and used that to time it. When I did the timing, I had the engine locked using the locking pin. (I forgot your previous advice shown in this post). The Laser set that I have has two sets of...

Both heads are off. Bent valves on both. No other visible damage. Piston tops and cylinder sleeves look ok. What other kind of damage can I expect? Are these rebuildable? Can I get away with just replacing the valves or is it common for the timing belt failure to case damage to...

The timing belt tensioner roller is definitely the weak part. Major scoring on the smooth surface. As I mentioned, this caused the timing belt to literaly shred. I will have to vacuum up the debris. When I look at the head from a different angle and upon further inspection - I see that there...

I have the front head off. No real visible damage to head or pistons. I can see "kiss marks" where the valves contacted the piston but nothing more. Please advise. I can't buy the engine, since I live in Sacramento, CA USA. Does that mean new valves are required? What is the most likely...

I just bought this as a project car. It has 85k miles. I loosened the timing belt cover and the timing belt is just shredded. Actually broken. the two rear camshaft belts look good. When I loosened the timing belt cover, a couple of ball bearings rolled out. . . So, the question is - what...