Search results

Hi, I cannot change gear with the engine running, i can change gear with the engine stopped, i can start in gear no problem. Master cylinder fine, i have removed the spring from the clutch inn the cab and there is still considerable pressure on the pedal, the pressure plate and release bearing...

Hi, I cannot change gear with the engine running, i can change gear with the engine stopped, i can start in gear no problem. I think it could be the master cylinder?, i have removed the spring from the clutch inn the cab and there is still considerable pressure on the pedal, which would say...

HI I havnet driven my land rover series since about April, now i try to get a gear and cant when the engine is running, is i switch off i can get all the gears. If i start the engine i cannot get any, the gearstick will go to the reverse selection, when i press in the clutch all seems the same...

Hi, I managed to replace the syncho clips without removing the gearbox, i road tested and all worked fine for about 2 miles, removed top of gearbox, and one of the synchor clips was partially out, the clips seem to be able to move back and forward in the synchro is this ok or should they be...

HI, Just managed to replace the synchro spings in my gearbox, the 3rd and 4th sysnchro was moving back and forward all ok. I have installed the selectors and put the cover back on. Now, i have reverse, 1st and 2nd but no 3rd or 4th, would the selector be in wrong way, There are no noises or...

Hi, I have replaced the buklhead in my series 3, the problem i now have is that the doors wont fit correctly, drivers door not to bad could eb adjusted, but the passengers door seems way off. It looks to be to low. 1 door ope is 35" and the other is 35.5". I wouldnt mind i took great care in...

Hi, Juest replaced bulkhead and my brake lights stay on all the time, i have checked the wiring to the brake pedal and its ok, Any ideas

Hi, Just wondering how you line up the seals for the bulkhead and windscreen, and also the roof to windscreen seal. Would clear mastic be ok the seal the bulkhead to wind screen. Thanks

Hi, I need to remove gearbox to replace syncro clips, i cannot figure out how to disconnect the driveshaft from the gearbox and the hand brake. Any pictures or advice would be great Peter

Hi, I just replaced my bulkhead and wings, i had removed the battery earth strap and connot remember where it should be connected to the body. Any help would be great

Hi, My gearstick is jammed and the gearbox is i think in third gear, when i clutch the it comes out of gear, but i cannot get the gearstick to move its jammed solid. Anu ideas,