Search results

Bit of an update folks. Left the car up to a mechanic to try to get the injector out for me. He welded a bolt on to the injector and got it out. He then put the new injector in and put everything back together again. Started 1st time and the car's been running ok for 2 weeks now :D Finger's...

Crap, that would be why it aint budging... Didnt know the torx studs had to come out too. I'll try to get a torx socket set on my way home from work in either BnQ or Hellfrauds. Anyone know what size of torx socket I'd need?

Took the intake manifold off yesterday, as well as the electrical connector on the injector and the fuel pipe to it. But, as predicted, it's refusing to come out. Tried everything (including a crow bar lol) to try to prise the thing out, but no joy. I'm wondering though, if I had a socket the...

Plan now is to get a replacement injector and replace the leaky one and pray this fixes the problem. If it doesn't I'll have to get it towed 35 miles to the nearest independent specialist :S Are there any guides for changing an injector on a Td4? Is it a big job?

Sorry for hijacking the thread, but are there any guides for changing an injector? One of my injectors is leaking and I want to replace it ASAP. I'll spray plenty of WD40 over the injector in question tonight or tomorrow morning and change it tomorrow evening after work if I can get a...

Is there any other way to tell if it's the injector causing the problem, before I buy one?

OK, well I tested the connector on the fuel pressure sensor and it is reading 5v and 0.5v from 2 of the wires, so the fuel pressure sensor seems OK. But, after reading about injectors etc, I think that leaky injector may be the cause of the problem, because it started on when being towed several...

I see. If I'm still getting no reading, then I'll open the ECU box and check the connections etc., and test for the voltage of the other end of the yellow/white wire (the end in the ECU box) incase the cable has been damaged or something.

Should the yellow/white wire in the green connector read 5 volts even when disconnected from the fuel pressure sensor? I'll check this when it stops raining outside.

I thought this myself, but I've fitted a replacement pump and it ran ok for a few minutes before it died again. I used a multimeter on the cam sensor... With the ign on, the connector on top of the engine block didn't give any readings from the 3 pins, but the connector that connects into this...

Yes I figured it was higher pressure that was causing the seal to break, but I meant is there anything that would cause this to happen? :confused: Thanks for the other info Dan, I'm going to go out and take voltage readings from both the fuel pressure sensor connector and the cam sensor...

Ok, tomorrow I'm going to use my Multimeter to test the Fuel Pressure sensor/connector. I'll take readings from the other side of the connector to see if the connector is faulty or not. Which of the 3 wires should I take the reading from and what should the typical voltages be? Also, if it was...

@ Mick - I have bought a replacement fuel filter, but haven't got it replaced yet. Where's the LP pump in the engine bay? I'm assuming LP means low pressure by the way. @ Skynet - If LP means Low Pressure, then no, it was the high pressure Bosch pump that was replaced from a breaker (The...

The seller of the tuning box was called MRMCBUK on Ebay. I emailed him about it and he says the most probable cause will be the connectors that connect to the fuel pressure sensor (maybe a lef broken or something) so I'll double check this later. I did the leak off test today. I clamped the...

Hi folks... I've posted on here before regarding my '03 Freelander 2.0 Td4 manual, but this is a fresh problem and has me baffled :S The car was running fine until a week or so ago. I bought a tuning box from Ebay (read around all different ones before I made the decision as to which to go...

Hey folks. I posted on here with the HDC fault light issue I had, before buying the Freelander, but now I've bought the Freelander and I love it so far. It's an 03 (pre-facelift) Td4 Kalahari manual. Few things I need advice on: 1.) I read that LR dealers can change the remote locking to...

Sorry buddy. Thought I had mentioned it was a manual :doh: I appreciate the help folks. Where should I be looking on the RAVE program to find info about the reverse switch? Would it be in the gearbox section? I used the search function for the word reverse and it only threw up one result.

Yes I know the brake light switch is a common problem, but my brake lights are working fine. It's my reverse lights playing up. That's why I'm guessing it's the reverse light switch. I'll check the brake light switch tomorrow to be on the safe side.

I found the RAVE CD and downloaded it, but still can't find anything about the reverse switch :S

I have this problem with my Freelander. Chaser, can you shed any light as to where I should check the circuits you mentioned? My reverse lights are coming on by themselves, so I think the reverse gear switch could be at fault. Do you know where to find the reverse gear switch on a td4? I can...