I agree with NickWhiteKent, Great Thread ! I am suffering the same malady but only with the fuel gauge, Will be having a look for my regulator with a view to it's replacement
Anybody Else fitted a radio THIS way ?.
Super all singing an Dancin' Radio from Lidl £30.
uses usb stick or SD card reader,
Takes up less room than Tape or CD player.
Lots more music and no storage probs
East Yorkshire.
Pair of Rear Parabolic Srings for Series 2a/3.
Garage fitted 2 years ago (April 2010) at 78,437, Removed by me at 49,400. I intend to fit new standard springs during this rebuild.
I'm Looking for £100 but will discuss any reasonable offer.
Cash on Pick up pse
I will obviously...
I've just renewed all the springs on my 73 Series 111. Make sure the pegs are located ! Then with weight on the truck and all bolts slack you have set the distance between spring and chassis. (Land rover w/s manual & Haynes give you the parameters. I had to get a mate to stand on the bumpers to...
I have seen in the past many items referring to replacing S3 seats.
I have searched the Threads and can't find any othe than a newish
one recomending Metro replacements
I am shortly of to visit my local scrappy so thought I would do my
homework before going, so as to save a lot of time...
I'm Still stuggling to get it right, I have purchased a 70A relay,
Still do not know if & where I earth out.
Anybody willing to take a photo of their Underbonnet Layout
for me to look at ?
[email protected]
My original wiring can be found at...
From arjjaze
These plugs Do Not earth through the screwed body section of the plug,
this is part of my dilemma, even with a direct power feed before the balast resistor I stlill get no power to the plugs. A diesel speciallist is on the card s BUT the car is currently SORN
thanks for the...
Hi Guys
Need a lot of help, I've been to 4x4 land rover specialists NO answer.
When I bought the series 3 [1973] the heater plugs had a new wiring circuit that did not go through the Ingnition/starter switch. A direct feed was taken from battery +ve - to 70 amp fuse, to push switch - to...
For lots of different reasons I have had to remove the seat box from my 1973
S3.
The workshop manual says to replace using a suitable sealant.
What is considered a suitable sealant ?
I don't realy want a flooded Cab every time I hit a deep puddle
Robert :rolleyes:
Hi Alan
Many thanks for your reply, Being brand new to Land Rovers I see the diagram
but can't work out where it fits. I would really like a couple of snap shots if you are prepared to do that for me, Cheers
Robert