Search results

hi a got a p38 just changed transfer box and front diff no problems run it a few times all ok just been to my mates and when i pulled it display gave a transfer neutral msg now if i start it and move selector into gear i can't get any and i try putting it back into park with engine running i get...

hi anyone got firing order for a 3.5efi

hi my mate just picked up a 87plate 3.5efi manual classic yesterday very cheap problem is when u go to accelorate it judders and jumps like hell it ticks over lovely tho, bloke he got it off has had ecu checked new patometer any one any ideas thanks

hi 4.6hse since the snow came my rangy is using a lot of water and a few times the temp gauge as gone into the red usually comes back down a little to take red light off.if i top it up in a morning with about 1 ltr it will run ok all day i can't find any leaks any ideas as i can't take it off...

hi i have a 95 4.6hse when going round corners i get a horrid grinding noise but it doesn't do it if i have a little speed.i thought it was front bearings but it ain't any ideas

hi need help p38 4.6hse 1995 when i turn left/right at slow speed i get a horrible grinding noise but it's not there if going at speed someone said it was bearings which i replaced but the noise is still there and now i also get traction failure and abs fault as soon as i pull away any ideas please

is auto transmission fluid same as diff oil

hi yesterday my rangy 4.6hse dumped all its water i looked under car but couldn't find anything so i refilled it no loss just a slight drip from near thermo housing drove the car another 20miles still only a slight drip then my missus nipped down road a hour or so later and it dumped it all...

hi a couple of weeks ago my rangy started to juder when i braked i changed the front brake pads which where shagged.my problem is now when i drive at about 50-60 i can feel a shudder throught sterring wheel and if i brake at the same speed the hole car starts to shake violently but doesn't do it...

hi i have a 95 4.6hse the past week or so i have had a horrid vibration and clunkin noise i got told it was the wheel bearings so i have replaced both hubs on back cos it was easier than splitting them now i have a clunking noise coming from what sounds like the back passenger wheel it does it...

every now and again i get a eas problem and the car jacks up if i switch it off for a minute or two it will be ok again. I brought a reset cable off ebay so i could clear the faults only i don't know where to plug it in i thought it was under the passenger seat only the plug on the height sensor...

HI can someone please help i have a RR classic 1988 with lpg conversion i have completly re built bottom half of engine piston rings mains big ends after i did it my rangy started and sounded lovely run it for a week,left it for a day then went to start it cos mot was due following day wouldn't...