Search results

And the implication of your post is exactly what?

I have a pair that are available. Not the brightest or cleanest axamples and are still attached to the bumper by the Specialist LR non removeable oxidised screws. The mounting frames are virtually intact and could easily be brought back to life. If you want photo's let me have an email...

Got a wheel carrier. £5 plus postage unless you are down Northants way.

DO you have the Multifunction Unit from behind the fuse box, AMR5360? If so, how much? Cheers

Do you have the Multifunction Unit from the back of the fuse box, AMR5360? If so, who much please?

PM sent.

Has anyone got an air conditioning belt tensioner (HRC2615) for a 300 Tdi? Cash waiting. Mark 07900 266366

As the title would suggest I would appreciate any guidance or links to help in swapping the oil pump in a ZF4HP22 auto box. Procedures, torque settings etc. Cheers

Unfortunatly we seem to have a problem with the gearbox following an engine swap and suspect that we have broken something along the way as there is no drive!! :arrghh: When we first started to tighten up the bell housing bolts a loud bang was heard. Our initial thoughts were that it was just...

Well from searching the internet I found a decent article on the RPI site. There, it says that the Lambda's run 0-1V but with a controlled voltage 'in' of 5v from the ECU. Problem is that the loom is from a NON cat/lambda car. THe Rangie did not have cats/Lambda's for the petrol system as it...

Sorry, totally lost me on that one. The car does not run lambda's nor does it have cats. I only need the lambda for the LPG ECU! The 'tune resistor!!!! Would |I be correct in assuming this regulates the voltage that goes to the Lambda +Volt red wire? If so, stupid question here, what does...

It is the original equipment Lucas Lambda, which in reality is an NGK sensor, that was fitted by the factory although a brand new one. It has three wires. Red 12V+, White Earth & black the signal wire (this connects the the shielded earth return to the ecu. This much I do know. What I need...

Long story short!! I have had to revert to the OEM Lambda sensors in a 3.9 cat exhaust (no cats as cut out and engine did not have them in the first place) not cheap £83.00. Problem is I cannot obtain the correct data to input into the AEB Leonardo Program. Even NGK Tech guys in Japan (who...

Sounds like your vapouriser needs adjusting.