Search results

just had a look its on pasinger side on top of chassis and near imposibal to get to fuel pipes on top of it and rocker covers half of it not a small job

hi rhs is that looking at front of car i/e pasinger side thanks i saw somthing on the petrol one sat on the chasis rail pasinger side

were is it located thanks john

myn came up on tester faulty i have a4.4 petrol one as well thats 2004 and it looks like a pump on left hand side of the chassis but just gesing i will check the back off engine as my heater is cold it never over heates runs in the middel of temp gauge

iv just done myn flatern were the bolts go so its flat and bolts ub good on both ends myn works ok now no blowing clean the rubber ring so it seales good luck john you should take inlet manifold off and check it these crack up but you can mend with rezin

were is the electric coolent pump on a2007 3.6 tdv8 put it on tester comes up pump not working my heater blows cold hoping this is the fault with it thanks john

thanks

were abouts can i fined it thanks john

its a comen fault and pepol think its gear box

the EKA code working as it starts now but can program key in

hi hope this might help others most range rovers hav a fault on them when gear box stops working every one hnks is box nacerd on the rear of the box there is a moter these stik or stop working and put the box in nutrall take the moter off inside theres a cog wined it in and try it...

iv had it every way under the sun still slow thanks john

hi its 57 plate 3.7 tdv8 its done it all the time iv had it i pulled the flap out of tank neck tryed other fuel shops and i can count up in penc whats going in tank am thinking of taking tank neck out

any one had probs puting fuel in tank cant do morthan £1 a time takes 30 mins to fill tank up it just keeps back preshering iv taken the flap out of tank nek still cant fill it fast thanks john

i got key blanks from ebay just no remote board or chip in them for the l322

cant get the key to work on central locking been told till that works i have to use eka code to get the emobiliser to work any one help with how to fix it thanks john so far i have had loads of help on hear its a 2.5 bmw derv t reg

hi got it undun if one of the catches works open it leaver up bonnet up put block under it you can undo the screws on grill with pliers remove grill the post were bonnet catch is bolted on to there is a hole in it but hard work trying to undo catch drill a big hole ferther up it makes it...

myns the same as that nasty ring round it and cloudy

hi i cant fined it thanks john