Search results

Hm played with it today paying more attention to exactly when it happens. Seems to be just as the turbo kicks in. I’m going to check the waste gate when I get time. Seems it could be possible and something I have not checked yet. Turbo is fine checked that but never touched the waste gate...

Jeez 800k must be rather well maintained. Mines only on 120k lol I don’t know how to explain it much better sorry, Rather loud bang rattling comes in low rpm under load - uphill. Sounds mechanical. Not heard at all cruising or accelerating on the flat in any gear. Checked everything I can see...

You have left me on tender hooks, what is this mystery information you are withholding?

Cheers you understood, I did mean the noise is stupid, I love the car have done much work to it

My first thoughts were exhaust too. I have replaced the right side engine mount as the rubber looked a bit perished. I cant move them with a crowbar so presumed them to be okay now.

Thanks for your reply, Yes it’s just a rattle, no other symptoms the car is driving just fine no stuttering smoke etc

I would love to hear what It was on yours. I did not mean that the d1 is stupid, I love my d1. I sold 2x l322s td6 and 3.6 tdv8 and kept the d1. That says something ;)

Yees front prop I bought new for this reason. It was a bit knackered. rear seems fine I can’t make it move on the joints

Hehe def not a farmyard noise 😂 Its loud metallic rattle doesn’t sound light like plinking or heat shield. There is only 1 heat shield I can see and it’s tight.

Hi, centre box is removed jsut the rear box installed Noise is from the front engine bay, axles, suspension area

Hi its a diesel

Hi 👋 I’m back with another frustrating d1 issue Its manual with egr removed no air con Car drives fine most of the time no noise Problem is that in higher gears 3-4 at lower rpm - 2-3k under load up hill there is a loud metallic rattling vibration noise. Coming from the front end somewhere...

Cheers guys much appreciated. I have managed to figure out sdd 163 with engineering mode. All free except the mongoose cable for about £60 Pretty dam good its got everything I will need and more up to 2017 models. chuffed :)

Thanks for all the replies. I now have the bmw software that will sort the early 322s. any one have any experience with the more inclusive hand held scanners? Autel or the launch x432?

Awesome thanks very much. That should cover my car at the moment. Planning a 3.6 or 4.4 tdv8 in the new year, jaguar electronics i believe. Any ideas on scanner for that one? Whats the best ones for all round LR?

Hia, I have searched but not found an answer yet. Car is 2004 L322 td6 Im looking for a half decent code reader with the bi detection functions. Important that it can also calibrate the air suspension. The bit where you enter numbers for each corner. I like the IID but run a small garage so...

Hi ive maybe heard it once or twice in past few months whilst stationary and even then for a second a tick tick and no more. 99.9% of the time nothing. Very noticeable when driving and from cold I am starting to thing clutch or gearbox tx box. Would clutch springs be able to tick tick. clutch...

Hi thanks for the reply No goes away when coasting and idle

Rollers in the little stub axle bit were done about a month ago trying to illuminate possibilities Cv has crossed my mind. Had them out not long ago though and no play. I cant put 2 tons on it though

Yes made the noise before the oil change All new on the front belt and tensioner included :-/