Search results

Is it all windows going down or just the tailgate? If it's just the tailgate,.. Does it have a removable rear half roof section? If so, mine does it all the time... There be a little actuator switch on the roof seal on the right side, check that's being engaged properly, I have all sorts of bits...

currently on a pc so cant upload the video im about to talk about,.. ive spoken to my trusty mechanic and showed him a video, as id taken the injector rail off, and took a short video of them all spraying , id told him all ive done and not done, now hes suggested theres wayy too much fuel being...

found the clutch problem,...a bent actuator arm , thanks guys

okay so here we are again, 1.8 k series engine cranks but wont turn over , it was fine when i parked it ...2 days later...it wont start... its tries too,.. it coughs slightly when turning the ignition on, that point with older vehicles where your brain goes '' go on...go on you tw@'' expecting...

thank you

thank you

thank you

it didnt look that bad tbf, only when we started removing the plastic trimming did it reveal itself

thank you

im building for trails, rtv1 and rtv2,

heres a rear/side view

as i say in the original post, ive spent just shy of 2k on it now, including the vynil wrap, 6 gang rocker switchbourd, new tyres, new prop shaft(as it had it removed and was fwd), new brakes, copper brake lines and braided hoses, cv joints/shafts, LED lighting bars, front, sides and rear...

more money spent, my wallet hates me haha

this was my sill last week

haha, im glad you looked at it, you are "supposed" to remove them first, but i did it intentionally, because i like to be and see diffrent, i kinda like the 3d effect,

thank you for your advice, its greatly appreciated, if after this week its still not freed up from oil dripping and working it in to attemp to unsieze it, the box will be coming off next week, im assuming the fork you speak of, is situated on the other end of the actuator arm im currently...

im so glad youve replied, as its your comments ive been following for the idea of the msc and bracket, followed by the clutch arm/actuator,... i think i did post in the fl section, but posted here first before i clicked about and found the fl section,.. anyhow, the arm is still stiff as a broom...

thanks budd

thank you

hello and thanks for having me, from swindon wiltshire, built 2 disco 2's and currently working on a fl1 1.8 poo series