Search results

Its a for FL2

Hi all , anybody know where the cabin temperature sensor fan is located and the module , i have two codes B105A-71 and U2101-00 Thanks

LOL tell me about it , ive done many CV joints and never had that , I smashed the F+++ out of it and NO way it was coming off . anyway , live and learn , thanks for your help , booked into Bell engeneering think i need a new PTU , great ££££££ Thanks for advice

Thanks for the reply , Yes it was the outboard CV i needed changing , NO WAY would it come off then i read from the manual ended up having to buy a new one as i need the car for tomorrow long drive , so its done but yes ebay would of been my port of call if i had time NOTE:The outer...

Hi All , so went to replace cv boot rear , got the shaft out in 10 minutes no problem got it on the bench can NOT get the old CV joint off the shaft , i thought it was just a snap ring as per normal and you tap the centre and it drops off , letting me put the new boot on ..... It just will not...

Great info , i understand what you mean now , i see the hole in the caseing , Until i can sort out my vibration problem which as of taking it out again today coasting in nutral its quiet but the noise bearing like sound and viabration that feels from the body appears on accelaration and off...

Thanks for the info , so you mean grab a couple of new rear diff seals ? and where the shaft goes into the diff you say there is a hole as where you can hit with a wedge tool and then will make the shaft pop out the diff < is that what you mean ? i guess it has a snap ring just the same as...

just noticed split outer rear CV boot ... and so the list is growing , do you know are the rear half shafts fairly straight forward as it disconnect stabiliser link undo the Nut and pull straight out of the Diff , i saw something about a special tool ? also something about an oil seal...

Haha , i hear you , great thanks ill go for that

Hi yup they are all Identical ..... so i need to take it to someone that to trust will give an honest opinion as the if the PTU is the problem and has too much play rather than telling me i just need to spend £500 or more on it .... i was going to check and change the oil , is this correct...

Thanks for your help , its done 119k may i ask where did you get yours , any recommendations

No play in the CV joints , just up and down play on the output flange , a fair bit , i know that goes to a spline and maybe the bearing that supports that has collapsed , im not sure https://we.tl/t-F4UhL65tfI this is the play

Is it possible on the PTU to take the prop off and run the car , i know some do on older versions ?

Thanks for getting back to me .... Yes it is called PTU , and my fl2 is also auto .. I was going to do a service on the Haldex myself , filter and fluid change until i discovered the play at the front , To answer your other questions , all Tyers are the same and in good condition , all...

HI all , so not long had my FL2 2009 hse . I've noticed when i accelorate / under load and take foot off gas viabration feeling like under body , not through steering or feeling on gear stick ... so i got under to take a look and i found play where the prop goes into the PTU , i think this...

Hi , can you recommend a good quality glow plug to buy for this cheers

Ill give that a try thanks

Hi all what would be the best glow plugs to replace ?

Just been down to a garage and asked about Glowplugs change ... looks like ill try it myself as they want £54 per hour and said they may snap in the head then it would be expensive so im not new to stripping down engines ill just have a go when i have time ... got a new relay coming s will try it

Not sure if they are rated the same