Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. E

    LT230 replacement rear oil seal leaking

    Can anyone advise please? I recently replaced the rear output oil seal on my 90. The following morning the catch pan is full of clean EP90 with a drip from the handbrake drum. I used a Bearmach replacement kit and replaced the rubber seal, felt washer and nylon nut. Is this common? I haven’t...
  2. E

    Carb rebuild didn’t fix it

    Help please, my 86 petrol 90 is struggling to run. I can get it to run but only just. Slightest touch of the accelerator and it dies. I’ve rebuilt the 32/34 dmtl carb but it will only just idle. The plugs turn black but dry. The mixture screw is only one full turn from closed. The fuel gauge...
  3. E

    Oil pressure light won’t illuminate

    Can any one help please? mom having ongoing trouble with my 1986 90 oil pressure light not working when I turn the ignition on. I have tried a replacement warning light unit. All other warning lights work. Turning the ignition on I get just the battery light which goes out on start up. I’ve...
  4. E

    Heater control wires

    Can anyone help please? After changing the oil pump on my 1986 90 this morning I noticed I have a loose control wire that is connected to the side of the heater matrix box be low the middle grommet. The cable ran across the car towards the brake servo but is terminated with a coil and not not...
  5. E

    Correct carb solenoid wiring colours and guage?

    After a bit of trouble staring this morning it's time to replace the old piece of mains lead that currently provides power to the two solenoid so on my 32/34 dmtl carb I'd its held in the right position! Can anyone tell me what the correct colour and guage should be used to replace these...
  6. E

    1986 90 RTC3023 Bonnet lock barrel replacement experience?

    Evening! I need to replace the lock barrel in my bonnet lock. Anyone got any useful experience advice on the best place to find appropriate replacement barrel and how to do it? Cheers
  7. E

    Searching a fuel sender that actually works

    Hi, I am struggling with my 1986 Petrol fuel gauge sender and finding a replacement part that actually works as it should. The vehicle has been off the road for 15 years or so and this is the last hurdle to getting back on the road reliably. I have tested the fuel gauge. 12v across the...
  8. E

    334111 interior lamp pad

    Good afternoon, I'm looking for a 334111 lamp mounting pad for the Lucas 562 interior light on my 1986 90. PA Blanchard was the only place I could find listing it online but they don't have any left. Anyone have a spare? Or know where I could find one? Cheers
Back
Top