Search results

Thanks for the invaluable info Nodge68. Radio will require code, but I have that so not a problem. Just bought a new ICanSoft I930 for £65 off Ebay, so at least I will be able to clear the codes initially and see if they return. Not sure whether it will diagnose any potential faults for the 3...

Not sure how I will read codes as I don't have appropriate equipment. If I disconnect the battery to fully charge it, would this clear the codes - I heard it would reset everything and also lock the Stereo requiring input of code. Alternatively, do you know of any resonably priced code readers...

Thanks, didn't really think that it would cause the fault codes, but as they only appeared when I turned the LR round to do work on the vehicle it seemed strange. I did have a problem with a low battery and needed to jump start the engine before turning it round, perhaps I dislodged a wire...

Hi, realise this thread is a little old, but today I noticed that the 3 amigos lit up on my FL1 TD4. No idea as to what the problem is, but the vehicle hasn't moved for a couple of weeks as I am doing some work to the window regulators and locks. However, just before I parked the FL I noted that...

Appreciate that and all the help you have provided. Will try FL for any further variants of the clips. Cheers. John.

Well I cannot speak for you and Brian, but I certainly am slowly going nutty - but there is definetly a hexagonal between the door card and the fixing point that goes into the door panel. On further reflection it might just be a spacer type of thing, but no idea why it should be hexagonal. BTW...

Thanks, hoping to gain some valuable information from extremely knowledgeable Landy owners.

Apologies for the duplicated post.

Aaah yes, now you point it out I can see the groove. Many thanks RangeRoller, should be able to replace them easily now. Just as a matter of interest, what is the nut shaped bit for in the middle of the clip? I assume now that you have explained the pin and groove, it helps turn the head on the...

Aaah yes, now you point it out I can see the groove. Many thanks RangeRoller, should be able to replace them easily now. Just as a matter of interest, what is the nut shaped bit for in the middle of the clip? I assume now that you have explained the pin and groove, it helps turn the head on the...

Many thanks for the reply. While I see this could work if the snapped clip was being removed from the door panel itself, I cannot quite understand how it would work removing the snapped clip from the door card? My reasoning for this would be that if it were as simple as screwing in a screw and...

Hi All, new to this forum, so apologies for any incorrect syntax. My daughter has a 2002 Freelander 1 2.0 TD4 and I have just replaced a door lock actuator and a window regulator - all common faults with the dear old Landy! While this procedure went well, a couple of the door card clips got...