Search results

thank you - I did indeed find them there .... as for the wiper hole bungs they are just 10mm grommets or which I had some already.

Morning all Just sorting out some tidying up of the defender. I’m after a couple of bits that I cannot find on the parts list or the retro ananconda document. Wondered if anyone knew the numbers they are the two rubber bumpers with a nipple on that go into the exterior bulkhead to stop the...

Morning all. Following the info here I have wired a td5 speedo into my 300tdi. I have wired all the pins in plug A with the exception of those for the alarm LED and ECU. when I plug it with ignition off the mileage display shows. Is this right ? If so what is the difference in operation of...

thanks

Hi - does anyone have a rear trim piece for a 1995 CSW 90 that goes above the back door. it’s the smaller piece in this picture. Thanks

No the live wire and it’s the big attached to the element the normal crimp plug attaches to

I think you are right re cleaning. I thought I had done a better job. Difference between what I can see and what my phone on end of my arm can see :0) got a feeling a spell under truck filming maybe in order.

In stripping old rear door to move stuff to new door I put the element tab that fell off the heated window somewhere safe. Now I can’t find it. Nor can I find a replacement online. anyone know where I might source one. It’s the metal tongue and pkate that gets glued to the element and the...

I did wonder that. But not sure.

I did wonder about those and Brake Fluid .... might need to try and catch some in a container rather than a cardboard sheet ....

EDIT sorry was too vague and now back with the landrover had a look and took photos. The liquid is honey in colour when it lands on the cardboard like fresh oil. But the engine oil on dipstick is black so not sure its engine oil. The leak runs quite quick when its happening and leaves a bubble...

Hi away from my 300tdi 1994 CSW at the moment pondering a recent and quite quick oil leak. cannot share pics as not with vehicle. But I am seeing oil roughly as ringed. I have degreased the engine and the leak is landing on the ground just behind front axle on rhs if looking at vehicle from...

Thanks for all your help. Had a look at the earth point on transfer case. Whilst cleaning it up discovered a broken crimp fix that meant earth wasn’t connected. Decent fix in place and all working. Thanks.

and by definition I could also run a earth wire from the chassis below that corner up into the tub to a Buss bar and connect there?

cool so the one from the tub to the chassis earths the tub and then the tub can be used to earth?

Hi there is no screwed down earth point in that corner and I was painting outside. It’s a duetsch (sp) connector and a bullet connector in the back. I could check wire to earth in case it got damaged but my recollection is in that corner it’s straight into loom and then earthed near transfer...

300tdi CSW 90 I recently removed all my rear lights to paint back of defender. Before removing all lights were working. replaced lights none on RHS working did usual checks and realised power was getting there so was earth issue. two earths in rear corner. The one from the loom that is...

Hi got these but can't find instructions. What order do the washers go? I assume bolt, washer, door, body, hinge? thanks

@murdomac any chance of a few pictures? thanks

Thanks for the replies - just to close the loop - Paintman Panels got back to me super quick this morning. murdomac you called it right maybe related to rear mounted wheels too.