Search results

Hi All, can anyone tell me where the part in the picture goes?It was in the plie for the back door when I stripped my series 3 18 months ago but I cannot remember where it fits, TIA

Hi, I have just finished the rebuild of my series 3 with 2.2 diesel engine. When I started it up all was fine but once on the road the needle went into the red. It is not boiling up so I think it is electrical? I swapped the temp sender for another new one and it made no difference. Fuel gauge...

Hi, can I ask advice on what type of theft equipment can be fitted to my series 3? It has a steering lock which is poor and also the engine stop is cable into it. I really don't want a padlock on the bonnet if I can help it, TIA

Hi I need help to identify parts that were removed from my land rover for its restoration. Not that good with computers so how do I upload pics? Thanks in advance

Hi I have bought a AUX switch panel for my series 3 but cannot work out where it fits in my dashboard any advice?TIA

Hi, I hope I have posted this in the right section? I could do with a picture of the front door seal set up please. The set supplied is straight forward with lining up the rivet holes and fitting them, but it also came with a long length of rubber trim. Does this glue on to the new trim or how...

Hi, I had a rear crankshaft oil leak, so I stripped the engine to remove the rear main bearing cap and the flywheel etc. As per the manual I fitted the split seal complete with the spring first, then the top seal retainer, then the main bearing with the bottom seal retainer making sure the...

Hi,trying to find the right section for my post? New to the site. Mine is a series 3 1974. I have identified and connected the indicator switch to all the wires on it apart from a plain blue wire. It seems to be from the headlamp flash section of the switch. Appreciate any advice and apologies...

Is it possible to slip out the corroded cross members that go across the way on a series 3 rear floor? they look riveted in some way?

Hi I have just purchased a 1974 series 3 for restoration. It has a galvanised chassis but the bulkhead is shot. I researched parts availability and help sites and found Landyzone so hopefully I will get answers to my many questions as I start the restoration